1. Basic concept of plc software data cable
2. Overview & installation of CX PROGRAMMER
3. Familiarization with various ladder symbol
4. Load controlling without latching circuit practical practice
5. Load controlling with latching practical practice
6. Introduction to set-reset command
7. Load controlling using set reset command
8. Introduction to Holding area and Programming Practice.
9. Familiarization with various types of Timers available in OMRON PLC.
10. On delay timer logic practical practice
11. Off delay timer logic practical practice
12. Twin timer logic practical practice
13. Retentive timer logic practical practice
14. Difference between Normal Timer vs Retentive Timer
15. Oscillating timer logic practical practice
16. Designing a Traffic Signal Using Oscillating Timer.
17. Designing a Flickering timer logic practical practice.
18. Familiarization with counters in omron plc
19. Introduction to Reversible Counters in omron plc.
20. Familiarization with Retentive Counters in omron plc
21. Counters Combined with proximity sensor and Timer Practical Practice.
22. Design a logic using set, reset, comparison & timer command to change the operating time of an output multiple times using a single timer.
23. By using Comparison Commands design a logic which will blink the output for any given time.
24. Design a logic using comparison command for any given requirement.
25. Design a Traffic Signal System by following a Certain time table chart.
26. Control an output Using counter and compare commands as per given requirement.
27. Control an output for multiple given time using one timer only and mov command.
28. Design a circuit to Change the time of a certain timer using increment and decrement command.
29. Design a circuit to blink a certain output using given delay time as per requirement.